NEN EN 13035-2 : 2008

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
  3.1 General definitions
  3.2 Definitions concerning equipment
4 List of significant hazards
  4.1 General
  4.2 During transportation
  4.3 During loading and unloading
  4.4 Flat glass transport by in-loader
5 Safety requirements and/or protective measures
  5.1 General
  5.2 General requirements
  5.3 Angle of lean
  5.4 Glass-retaining systems
  5.5 Bearers and cladding materials
  5.6 Special transport systems
      5.6.1 In-loader vehicle
      5.6.2 Frail on truck and van
      5.6.3 Stillages and pallets
  5.7 Vacuum lifting device
6 Verification of safety requirements and/or protective measures
7 Information for use
  7.1 General
  7.2 Signals and warning devices
  7.3 Accompanying documents
  7.4 Marking
Annex A (informative) Types of equipment
Annex B (informative) Guidelines for the glass-retention devices
      B.1 Hydraulic and pneumatic supports
      B.2 Air bags/cushions
      B.3 Stanchions for supports on frails
      B.4 Protection of the belt against glass impacts by means of
          an edge protection
      B.5 Straps
Annex C (informative) Symbols for labels and signs
Annex ZA (informative) Relationship between this European Standard
                       and the Essential Requirements of EU-Directive
                       98/37/EC
Annex ZB (informative) Relationship between this European Standard
                       and the Essential Requirements of EU Directive
                       2006/42/EC
Bibliography

Specifies the requirements for safety for the design and installation of equipment intended for the storage, handling and transportation of flat glass outside the factory and including stillages, pallets, frails fixed to vehicles, in-loader vehicles, specific glass-securing devices, stanchions and vacuum-lifting devices which are used for road transport and on building sites.