Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols, units and abbreviated terms
3.1 Terms and definitions
3.2 Symbols, units and abbreviated terms
4 Requirements
4.1 General
4.2 Thermal resistance
4.3 Mechanical resistance and stability of the system
4.3.1 Bond strength of the base coat to the MW board
4.3.2 Bond strength of the adhesive to the MW board for ETICS
fixed by an adhesive
4.3.3 Pull-off resistance of the ETICS fixed by mechanical fixing
4.4 Reaction to fire
4.5 MW boards
4.6 Tensile strength of the reinforcement
4.7 Liquid water permeability of the system surface
4.8 Resistance to impact
4.9 Resistance to penetration
4.10 Water vapour permeability
4.11 Durability and adhesion of the finishing material on the base
coat
5 Test methods
5.1 Sampling
5.2 Conditioning
5.2.1 Conditioning of the test specimen for the determination of
the tensile bond strength of the adhesive to the thermal
insulation material
5.2.2 Conditioning of the test specimen in accordance with
EN 1062-11 for the determination of the tensile bond
strength of the base coat to the thermal insulation
material, liquid water permeability of the system surface,
resistance to impact, resistance to penetration, water
vapour permeability, durability and adhesion of the
finishing material on the base coat
5.3 Testing
6 Designation code
7 Evaluation of conformity
8 Marking and labelling
8.1 The entire and specific information of all components of the kit
has to be given on an accompanying document that contains:
8.2 Components conforming to this standard shall be clearly
marked, either on the product or on the label with the following
information:
8.3 Additional information:
8.3.1 Reinforcement
8.3.2 Adhesive
8.3.3 Base coat
8.3.4 Finishing coat
8.3.5 MW-Boards
8.3.6 Rails
8.3.7 Anchors
Annex A (normative) Factory production control
Annex B (informative) Additional information for customer and
designers
B.1 Resistance of the systems surface to cracking
Bibliography