NEN EN 14658 : 2005 + A1 2010

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
  4.1 General
  4.2 Mechanical hazards
      4.2.1 Crushing and shearing
      4.2.2 Entanglement, drawing-in and trapping
      4.2.3 Stability
      4.2.4 Hazards generated by fracturing and rupturing
            during operation
      4.2.5 Hazards generated by slipping, tripping
            and falling
  4.3 Electrical equipment hazards
  4.4 Thermal hazards
  4.5 Radiation hazards
  4.6 Hazards due to handled materials
  4.7 Hazards due to neglect of ergonomic principles
  4.8 Hazards due to energy supply failure
  4.9 Combination of hazards
5 Safety requirements and/or measures
  5.1 General
  5.2 Mechanical hazards
      5.2.1 Crushing and shearing hazards
      5.2.2 Entanglement, drawing-in and trapping
      5.2.3 Stability
      5.2.4 Hazards generated by fracturing and rupturing
            during operation
      5.2.5 Access
  5.3 Electrical equipment requirements
      5.3.1 General
      5.3.2 Start-up
      5.3.3 Stopping, restarting after actuation of
            the stop device
      5.3.4 Unexpected or unintended start-up
  5.4 Thermal hazards
  5.5 Radiation hazards
  5.6 Hazards due to handled materials
  5.7 Hazards due to neglect of ergonomic principles
  5.8 Hazards due to energy supply failure
  5.9 Combination of hazards
6 Verification of compliance with safety
  requirements and/or measures
  6.1 General
  6.2 Documents demonstrating compliance at the
      design/manufacturing stages
  6.3 Verification at the place of installation
7 Information for use
  7.1 General
  7.2 Signals and warning devices
  7.3 Accompanying documentation (operating
      instruction handbook)
      7.3.1 General
      7.3.2 Information on the continuous handling equipment
      7.3.3 Instructions for the use of the continuous
            handling equipment
      7.3.4 Instructions for maintenance
  7.4 Marking
Annex A (normative) List of hazards according to EN 1050
                       and reference to the corresponding
                       safety requirements to be met by continuous
                       handling equipment in opencast lignite
                       mining
Annex ZA (informative) Relationship between this European
                       Standard and the Essential Requirements
                       of EU Directive 98/37/EC amended by
                       Directive 98/79/EC

Defines the safety requirements for stationary, mobile and shiftable continuous handling equipment designed to transport bulk goods by continuous movement from a loading point to a discharge point. Applies to continuous handling equipment operating in delimited site areas that are off-limits to the public and accessible only to authorized persons.