NEN EN 14783 : 2013

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
  4.1 Materials
  4.2 Nominal thickness
  4.3 Water permeability
  4.4 Dimensional change
  4.5 Dimensional tolerances
  4.6 Vapour and air permeability
  4.7 Release of dangerous substances
  4.8 Durability
  4.9 External fire performance
  4.10 Reaction to fire
5 Testing, assessment and sampling methods
  5.1 External fire performance for roof covering products
       5.1.1 Products deemed to satisfy the requirements
              for external fire performance
       5.1.2 Products classified without the need for
              further testing
       5.1.3 Other products
  5.2 Reaction to fire
       5.2.1 Products satisfying the requirements for
              reaction to fire Class A1 without the need
              for testing
       5.2.2 Other products
  5.3 Release of dangerous substances
6 Evaluation of conformity
  6.1 General
  6.2 Initial type testing (ITT)
       6.2.1 General
       6.2.2 Sampling for ITT
  6.3 Factory production control (FPC)
       6.3.1 General
       6.3.2 General requirements
7 Designation
8 Product marking
Annex A (normative) Multilayer coated steel sheet
  A.1 General
  A.2 Substrate material
  A.3 Specific requirements
       A.3.1 Minimum nominal values of thickness
       A.3.2 Bituminous coating specification
       A.3.3 Durability
  A.4 Freedom from defects
Annex B (normative) Test conditions for the reaction to
                    fire tests
  B.1 General
  B.2 Mounting and fixing conditions of test specimens
       in the SBI test
       B.2.1 General
       B.2.2 General configuration
       B.2.3 Securing the overlap vertical joint
       B.2.4 Standard assembly-steel corner flashings
       B.2.5 Alternative assembly-corner flashings and seals
  B.3 Test arrangement for reaction to fire test according
       to EN ISO 11925-2
Annex ZA (informative) Clauses of this European Standard
                       addressing the provisions of EU
                       Construction Products Directive
  ZA.1 Scope and relevant characteristics
  ZA.2 Procedure(s) for the attestation of conformity of
       products
       ZA.2.1 Systems of attestation of conformity
       ZA.2.2 Declaration of conformity
  ZA.3 CE marking and labelling
Bibliography

Specifies the terminology, requirements and test methods for metal coil, strip, and flat sheets and factory made pieces intended for fully supported applications in roofing and wall cladding or lining.