NEN EN 15061 : 2007 + A1 2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or measures
  5.1 General design requirements
  5.2 List of significant hazards, hazardous situations,
      safety requirements and/or measures for terminal
      equipment
  5.3 List of significant hazards, hazardous situations,
      safety requirements and/or measures for processing
      equipment
  5.4 Special safety requirements or measures
  5.5 Noise reduction as a safety requirement
6 Verification of the safety requirements and/or measures
7 Information for use
  7.1 General
  7.2 Safety signs and warning devices
  7.3 Minimum marking
  7.4 Instruction handbook
  7.5 Maintenance manual
Annex A (normative) - Safety requirements and/or measures for
                      electrical equipment
  A.1 Foreword
  A.2 Special requirements for controls
  A.3 Special requirements for shut-down equipment
      A.3.1 Stop functions/emergency stop functions
      A.3.2 Specific hazards at mechanical equipment
      A.3.3 Selection of stop functions
      A.3.4 Emergency stop areas
      A.3.5 Stop functions
Annex B (normative) - Noise test code
  B.1 Introduction
  B.2 Determination of A-weighted sound power level
  B.3 Determination of A-weighted emission sound
      pressure levels at work stations
      B.3.1 Determination of the A-weighted emission
            sound pressure levels at specified measuring
            points
      B.3.2 Determination of A-weighted emission sound
            pressure levels at work stations
  B.4 Measurement uncertainty
  B.5 Operating conditions
  B.6 Information to be recorded and reported
  B.7 Declaration and verification of noise emission values
Annex C (informative) - Example for manufacturer's safety
                        instructions for maintenance at
                        strip processing lines
  C.1 Hazards caused by a lack of instructions
  C.2 Hazards caused by visual or audible checks
      at machinery in motion
  C.3 Hazards caused by unintentional movements during
      maintenance
  C.4 Hazards at work during standstill with safeguards
      disabled
  C.5 Hazards arising from work with hazardous substances
  C.6 Hazards arising from plant re-start
Annex D (informative) - Exemplary solutions
Annex ZA (informative) - Relationship between this European
                         Standard and the Essential
                         Requirements of EU Directive 98/37/EC
Bibliography

Specifies the health and safety requirements of strip processing lines. It also deals with all significant hazards, hazardous situations and events relevant for strip processing line machinery and equipment, when used as intended and under conditions foreseen by the manufacturer, but also includes foreseeable faults and malfunctions in case of misuse.