NEN EN 1760-3 : 2004 + A1 2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
  4.1 General
  4.2 Basic requirements
  4.3 Specific requirements for pressure sensitive bumpers
  4.4 Additional requirements for pressure sensitive plates
  4.5 Specific requirements for pressure sensitive wires
      (Trip wires)
5 Marking
  5.1 General
  5.2 Labels
  5.3 Reference numbers
6 Information for selection and use
  6.1 General
  6.2 Essential data for the selection of a suitable
      device
  6.3 Information for use
7 Verification
  7.1 Verification of requirements applicable to all
      pressure sensitive protective devices covered by
      this part of EN 1760
  7.2 Verification of requirements for pressure sensitive
      bumpers only
  7.3 Verification of requirements for pressure sensitive
      plates only
  7.4 Verification of requirements for pressure sensitive
      wires
  7.5 Other tests
Annex A (normative) Timing diagrams
Annex B (informative) Explanatory notes concerning device
        characteristics
Annex C (informative) Design notes
  C.1 General
  C.2 Pressure sensitive bumpers
  C.3 Pressure sensitive plates
  C.4 Pressure sensitive wires
Annex D (informative) General application notes
  D.1 General
  D.2 Application of the sensor
  D.3 Sensor mounting
  D.4 Sensor positioning
  D.5 Force imparted by the sensor
Annex E (informative) Notes on concerning commissioning
        and inspection
  E.1 General
  E.2 System information
  E.3 Commissioning
  E.4 Information for regular inspection and tests
  E.5 Inspection and tests after maintenance
Annex ZA (informative) Relationship between this European
         Standard and the Essential Requirements of EU
         Directive Machinery 98/37/EC
Bibliography

Defines requirements for pressure sensitive protective devices with and without an external reset facility.