NEN EN 1870-15 : 2012

Foreword
0 Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or measures
  5.1 General
  5.2 Controls
      5.2.1 Safety and reliability of control systems
      5.2.2 Position of controls
      5.2.3 Starting
      5.2.4 Normal stopping
      5.2.5 Emergency stop
      5.2.6 Integrated feed
      5.2.7 Control duplication
      5.2.8 Failure of the power supply
      5.2.9 Failure of the control circuits
  5.3 Protection against mechanical hazards
      5.3.1 Stability
      5.3.2 Risk of break-up during operation
      5.3.3 Tool holder and tool design
      5.3.4 Braking
      5.3.5 Devices to minimise the possibility or the effect of
             ejection
      5.3.6 Work-piece supports and guides
      5.3.7 Prevention of access to moving parts
  5.4 Protection against non-mechanical hazards
      5.4.1 Fire
      5.4.2 Noise
      5.4.3 Emission of chips, dust and gases
      5.4.4 Electricity
      5.4.5 Ergonomics and handling
      5.4.6 Lighting
      5.4.7 Pneumatic
      5.4.8 Hydraulic
      5.4.9 Electromagnetic compatibility
      5.4.10 Laser
      5.4.11 Static electricity
      5.4.12 Errors of fitting
      5.4.13 Isolation
      5.4.14 Maintenance
6 Information for use
  6.1 General
  6.2 Warning devices
  6.3 Marking
  6.4 Instruction handbook
Annex A (normative) Saw spindle dimensional tolerances
Annex B (normative) Stability test for the deterring/impeding
                       device required in 5.3.7.1.2
Annex C (normative) Operating conditions for noise emission
                       measurement
Annex ZA (informative) Relationship between this European Standard and
                       the Essential Requirements of EU Directive 98/37
Bibliography

Defines all requirements and/or measures to reduce the hazards and limit the risks on multi-blade cross-cut sawing machines with integrated feed of the work-piece and manual loading and/or unloading fitted with a saw blade drive motor for each saw unit, hereinafter referred to as "machines", designed to cut solid wood, chipboard, fibreboard, plywood and also these materials where they are covered with plastic edging and/or plastic/light alloy laminates, when they are used as intended and under the conditions foreseen by the manufacturer including reasonably foreseeable misuse.