NEN EN 1993-5 : 2008 C1 2009

Foreword
1 General
  1.1 Scope
  1.2 Normative references
  1.3 Assumptions
  1.4 Distinction between principles and application rules
  1.5 Definitions
  1.6 Symbols
  1.7 Units
  1.8 Terminology
  1.9 Convention for sheet pile axes
2 Basis of design
  2.1 General
  2.2 Ultimate limit state criteria
  2.3 Serviceability limit state criteria
  2.4 Site investigation and soil parameters
  2.5 Analysis
  2.6 Design assisted by testing
  2.7 Driveability
3 Material properties
  3.1 General
  3.2 Bearing piles
  3.3 Hot rolled steel sheet piles
  3.4 Cold formed steel sheet piles
  3.5 Sections used for waling and bracing
  3.6 Connecting devices
  3.7 Steel members used for anchors
  3.8 Steel members used for combined walls
  3.9 Fracture toughness
4 Durability
  4.1 General
  4.2 Durability requirements for bearing piles
  4.3 Durability requirements for sheet piling
  4.4 Corrosion rates for design
5 Ultimate limit states
  5.1 Basis
  5.2 Sheet piling
  5.3 Bearing piles
  5.4 High modulus walls
  5.5 Combined walls
6 Serviceability limit states
  6.1 Basis
  6.2 Displacements of retaining walls
  6.3 Displacements of bearing piles
  6.4 Structural aspects of steel sheet piling
7 Anchors, walings, bracing and connections
  7.1 General
  7.2 Anchorages
  7.3 Walings and bracing
  7.4 Connections
8 Execution
  8.1 General
  8.2 Steel sheet piling
  8.3 Bearing piles
  8.4 Anchorages
  8.5 Walings, bracings and connections
A [normative] - Thin walled steel sheet piling
  A.1 General
  A.2 Basis of design
  A.3 Properties of materials and cross-sections
  A.4 Local buckling
  A.5 Resistance of cross-sections
  A.6 Design by calculation
  A.7 Design assisted by testing
B [informative] - Testing of thin walled steel sheet piles
  B.1 General
  B.2 Single span beam test
  B.3 Intermediate support test
  B.4 Double span beam test
  B.5 Evaluation of test results
C [informative] - Guidance for the design of steel sheet piling
  C.1 Design of sheet pile cross section at ultimate limit state
  C.2 Serviceability limit state
D [informative] - Primary elements of combined walls
  D.1 I-sections used as primary elements
  D.2 Tubular piles used as primary elements

Describes principles and application rules for the structural design of bearing piles and sheet piles made of steel.