NEN EN 848-1 : 2007 + A2 2012

Foreword
0 Introduction
1 Scope
2 Normative references
3 Definitions and terminology
   3.1 Definitions
   3.2 Terminology
4 List of hazards
5 Safety requirements and/or measures
   5.1 Controls
   5.2 Protection against mechanical hazards
   5.3 Protection against non-mechanical hazards
6 Information for use
   6.1 Warning devices
   6.2 Marking
   6.3 Instruction handbook
Annex A (normative) Determination of maximum spindle speeds
Annex B (normative) Rigidity test for pressure pads, hand
        protector and guiding steady
Annex C (normative) Safe working practice
Annex ZA (informative) Clauses of this European Standard
         addressing essential requirements or other
         provisions of EU Directives

Defines all significant hazards, hazardous situations and events which are relevant to stationary and displaceable hand fed single spindle vertical moulding machines (with or without demountable power feed unit), herein after referred to as "machines", designed to cut solid wood, chip board, fibreboard, plywood and also these materials if they are covered with plastic laminate or edgings when they are used as intended and under the conditions foreseen by the manufacturer.