NEN EN ISO 19432 : 2012

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and verification
  5.1 General
  5.2 Handles
  5.3 Speed
  5.4 Engine stopping device
  5.5 Throttle control
  5.6 Clutch
  5.7 Exhaust gases
  5.8 Cutting debris discharge
  5.9 Tank openings
  5.10 Protection against contact with parts under high
       voltage
  5.11 Transmission cover(s)
  5.12 Protection against contact with hot parts
  5.13 Cut-off wheel guard
  5.14 Flange locking device
  5.15 Flange assembly
  5.16 Spindle diameter
  5.17 Special tools
  5.18 Noise
  5.19 Vibration
6 Information for use
  6.1 Instruction handbook
  6.2 Markings
  6.3 Warnings
Annex A (normative) Strength test of cut-off wheel guard
Annex B (normative) Noise test code - Engineering method
                    (grade 2 of accuracy)
Annex C (normative) Measurement of vibration values at
                    the handles
Annex D (informative) Recommended pictorials and symbols
ANNEX ZA (informative) Relationship between this
         International Standard and the Essential
         Requirements of EU Directive 98/37/EC,
         amended by Directive 98/79/EC
Bibliography

Defines safety requirements and their verification for the design and construction of portable, hand-held, internal combustion engine driven, cut-off machines, intended to be used by a single operator in the cutting of construction materials, such as asphalt, concrete, stone and metal.