NEN EN ISO 2503 : 2009 AMD 1 2015

Foreword
1 Scope
2 Normative references
3 Definition
4 Terminology
5 Units
    5.1 Pressure
    5.2 Flow
    5.3 Temperature
6 Manufacturing requirements
    6.1 Materials
    6.2 Design, machining and assembly
7 Types of connections
    7.1 Inlet connections
    7.2 Outlet connections
8 Physical characteristics
    8.1 Pressures
    8.2 Flow rates
    8.3 Equipment classes
    8.4 Operating characteristics
9 Marking
10 Instructions for use
11 Type test procedure
    11.1 General
    11.2 Test samples and necessary documents
    11.3 Test conditions
    11.4 Functional tests
    11.5 Mechanical tests
    11.6 Test for durability of markings
Annex ZA (normative) Normative references to
         International publications with their
         relevant European publications
Figures
      1 - Diagram of a pressure regulator and
           designation of its components
      2 - Typical dynamic expansion curves
      3 - Example for the measurement of the maximum
          discharge, Qmax
      4 - Example for the measurement of the dynamic
          expansion curves
      5 - Test bench for ignition test
      6 - Test interval
Tables
      1 - List of terms
      2 - Conversion, coefficient, U
      3 - Symbols used
      4 - Equipment classes
      5 - Code letters for gases to be used for marking
          of pressure regulators
      6 - Test pressures

Defines requirements for single or two-stage pressure regulators without flowmetering devices for connection to gas cylinders used for compressed gases up to 300 bar (30 MPa), dissolved acetylene, liquefied petroleum gases (LPG), methylacetylene-propadiene mixtures (MPS), and carbon dioxide (CO[2]), for use in welding, cutting and allied processes.