NF EN 1175-2 : 1998 + A1 2011

Foreword
0 Introduction
1 Scope
2 Normative references
3 Definitions
4 List of hazards
5 General requirements
    5.1 Starter battery
          5.1.1 Insulation
          5.1.2 Constraining
          5.1.3 Disconnection
    5.2 Protection of circuits
    5.3 Safety related control systems
          5.3.1 Low voltage
          5.3.2 Frame fault
          5.3.3 Load handling control
          5.3.4 Speed limitation
          5.3.5 Steering control
    5.4 Wiring practices, conductors and electrical
          components
          5.4.1 Protection
          5.4.2 Cross-sectional area
          5.4.3 Specification
          5.4.4 Fuel leakage
          5.4.5 Mechanical protection
          5.4.6 Wiring that flexes
          5.4.7 Identification
    5.5 Protection against electric shock
6 Information for use
    6.1 Electrical diagram
    6.2 Safety checks
Annex ZA (informative) Clauses of this European Standard
addressing essential requirements or other provisions of
EU Directives

Defines the electrical and related mechanical safety requirements for designing and constructing electrical installation in internal combustion engine powered trucks, having starter battery nominal voltages not exceeding 24 V. Describes specified hazards which could happen during intended truck use, under specific climatic conditions.