NFPA 1802:2021

Chapter 1 Administration 1.1 Scope. 1.2 Purpose. 1.3 Application. 1.4 Units. Chapter 2 Referenced Publications 2.1 General. 2.2 NFPA Publications. 2.3 Other Publications. 2.4 References for Extracts in Mandatory Sections. (Reserved) Chapter 3 Definitions 3.1 General. 3.2 NFPA Official Definitions. 3.3 General Definitions. Chapter 4 Certification 4.1 General. 4.2 Certification Program. 4.3 Inspection and Testing. 4.4 Annual Verification of Product Compliance. 4.5 Manufacturers’ Quality Assurance Program. 4.6 Failure Mode and Effects Analysis (FMEA) for RF Devices and RSMs. 4.7 Hazards Involving Compliant Product. 4.8 Manufacturers’ Investigation of Complaints and Returns. 4.9 Manufacturers’ Safety Alert and Product Recall Systems. Chapter 5 Product Labeling and Information 5.1 Product Label Requirements. 5.2 User Information. Chapter 6 Design Requirements 6.1 General Design Requirements. 6.2 Hazard Zone Mode. 6.3 Location of Controls and Features. 6.4 Power/Volume Knob. 6.5 Selector Knob. 6.6 Display. 6.7 Visual Indicators. 6.8 Emergency Alert Button (EAB). 6.9 Remote Speaker Microphone. 6.10 RF Device Connector (RFDC). 6.11 Failure Detection of Connected RSMs. 6.12 Voice Announcement. 6.13 Out-of-Range Detection. 6.14 Audible and Visible Event Indications. 6.15 Visible Event Indications. 6.16 Internal Over-Temperature Event Indications. 6.17 Device Self-Checks. 6.18 Database Requirements. 6.19 Data Logging. 6.20 RF Wireless Interface (RFWI). 6.21 Data Commands. 6.22 Hazardous Location Requirements. Chapter 7 Performance Requirements 7.1 RF Device and RSM Requirements. 7.2 RF Device Requirements. 7.3 RF Antenna Requirements. Chapter 8 Test Methods 8.1 Sample Preparation. 8.2 Speech Quality Test. 8.3 Heat and Immersion Leakage Resistance. 8.4 Vibration Test. 8.5 Impact Acceleration Resistance Test. 8.6 Corrosion Test. 8.7 Display Surface Abrasion Test. 8.8 High-Temperature Functionality Test. 8.9 Heat and Flame Test. 8.10 Product Label Durability Test. 8.11 Cable Pullout Test. 8.12 Case Integrity Test. 8.13 Water Drainage Test. 8.14 Tumble — Vibration Test. 8.15 TIA Transmit Power. 8.16 TIA Carrier Frequency Stability. 8.17 TIA Receiver Sensitivity. 8.18 Power Source Performance Test. 8.19 Electronic Temperature Stress Test. 8.20 Antenna VSWR Swept Frequency Test. Annex A Explanatory Material Annex B Informational References

This standard shall identify the operating environ‐ ment parameters, as well as the minimum requirements for the design, performance, testing, and certication of portable RF voice communications devices (RF devices) and remote speaker microphones (RSMs) for use by emergency services personnel (ESP) within the hazard zone during emergency incident operations without compromising compatibility with eld emergency services communications networks.