NS EN 10147 : 2ED 2000

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
      4.1 Classification
      4.2 Designation
5 Information to be supplied by the purchaser
      5.1 Mandatory information
      5.2 Options
6 Manufacturing process
7 Requirements
      7.1 Mechanical properties
      7.2 Coatings
      7.3 Coating finish
      7.4 Surface quality
      7.5 Surface treatment (surface protection)
      7.6 Freedom from coil breaks
      7.7 Coating mass
      7.8 Adhesion of coating
      7.9 Surface condition
      7.10 Tolerances on dimensions and shape
      7.11 Suitability for further processing
8 Testing
      8.1 General
      8.2 Test units
      8.3 Number of tests
      8.4 Sampling
      8.5 Test methods
      8.6 Retests
      8.7 Inspection documents
9 Marking
10 Packing
11 Storage and transportation
12 Disputes
Annex A (normative) Reference method for determination of
                    the zinc coating mass
Annex B (informative) List of corresponding former
                      designations
Bibliography

Gives the requirements for continuously hot-dip zinc coated flat products in thicknesses <= 3,0 mm made of the steels given in table 1. Applicable to strip of all widths and to sheets cut from it (>= 600 mm width) and cut lengths (< 600 mm width). The types of coating, coating masses and coating finishes available and surface qualities are also given.