NS EN 1218-2 : 2004 + A1 2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
  3.1 General
  3.2 Terms
  3.3 Definitions
4 List of hazards
5 Safety requirements and/or measures
  5.1 General
  5.2 Controls
      5.2.1 Safety and reliability of control systems
      5.2.2 Position of controls
      5.2.3 Starting
      5.2.4 Stop controls
      5.2.5 Emergency stop
      5.2.6 Integrated feed
      5.2.7 Mode selection
      5.2.8 Speed changing
      5.2.9 Control duplication
      5.2.10 Failure of the power supply
      5.2.11 Failure of the control circuits
  5.3 Protection against mechanical hazards
      5.3.1 Stability
      5.3.2 Risk of break-up during operation
      5.3.3 Tool holder and tool design
      5.3.4 Braking
      5.3.5 Devices to minimise the possibility or
             the effect of ejection
      5.3.6 Workpiece supports and guides
      5.3.7 Prevention of access to moving parts
  5.4 Protection against non-mechanical hazards
      5.4.1 Fire
      5.4.2 Noise
      5.4.3 Emission of chips and dust
      5.4.4 Electricity
      5.4.5 Ergonomics and handling
      5.4.6 Lighting
      5.4.7 Pneumatics
      5.4.8 Hydraulics
      5.4.9 Radiation
      5.4.10 Static electricity
      5.4.11 Errors of fitting
      5.4.12 Isolation
      5.4.13 Maintenance
6 Information for use
  6.1 Warning devices
  6.2 Marking
  6.3 Instruction handbook
Annex A (informative) Examples of safety related control systems
Annex B (normative) Tool spindle dimensional tolerances
Annex C (informative) Safe working practice
Annexe ZA (informative) Relationship of this document with EC
          Directives
Bibliography

Describes the requirements and/or measures to remove the hazards and/or limit the risks on double end tenoning and/or profiling machines fed by chain or chains, hereinafter referred to as the machine, designed to cut solid wood, chipboard, fibreboard or plywood and also these materials where they are covered with plastic laminate or edgings.