NS EN 1218-4 : 2004 + A2 2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
  3.1 General
  3.2 Terms
  3.3 Definitions
4 List of hazards
5 Safety requirements and/or measures
  5.1 General
  5.2 Controls
      5.2.1 Safety and reliability of control systems
      5.2.2 Position of controls
      5.2.3 Starting
      5.2.4 Stop controls
      5.2.5 Emergency stop
      5.2.6 Integrated feed
      5.2.7 Mode selection
      5.2.8 Speed changing
      5.2.9 Control duplication
      5.2.10 Failure of the power supply
      5.2.11 Failure of the control circuits
  5.3 Protection against mechanical hazards
      5.3.1 Stability
      5.3.2 Risk of break-up during operation
      5.3.3 Tool holder and tool design
      5.3.4 Braking
      5.3.5 Devices to minimise the possibility or the effect
             of ejection
      5.3.6 Work-piece supports and guides
      5.3.7 Prevention of access to moving parts
  5.4 Protection against non-mechanical hazards
      5.4.1 Fire
      5.4.2 Noise
      5.4.3 Emission of chips, and dust
      5.4.4 Electricity
      5.4.5 Ergonomics and Handling
      5.4.6 Lighting
      5.4.7 Pneumatics
      5.4.8 Hydraulics
      5.4.9 Heat
      5.4.10 Substances
      5.4.11 Radiation
      5.4.12 Static Electricity
      5.4.13 Errors of fitting
      5.4.14 Isolation
      5.4.15 Maintenance
6 Information for use
  6.1 Warning devices
  6.2 Marking
  6.3 Instruction handbook
Annex A (informative) Examples of safety related control systems
Annex B (normative) Tool spindle dimensional tolerances
Annex C (informative) Safe working practice
Annex ZA (informative) Relationship of this document with EC
         Directives
Bibliography

Describes the requirements and/or measures to remove the hazards and/or limit the risks on edge banding machines fed by chain(s) where the loading and unloading is manual and where the maximum work-piece height capacity is 75 mm.