NS EN 1218-5 : 2004 + A1 2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
  3.1 General
  3.2 Terms
  3.3 Definitions
4 List of significant hazards
5 Safety requirements and/or measures
  5.1 General
  5.2 Controls
      5.2.1 Safety and reliability of control systems
      5.2.2 Position of controls
      5.2.3 Starting
      5.2.4 Normal stopping
      5.2.5 Emergency stop
      5.2.6 Integrated feed
      5.2.7 Positioning of tool spindles
      5.2.8 Speed changing
      5.2.9 Failure of the power supply
      5.2.10 Failure of control circuits
  5.3 Protection against mechanical hazards
      5.3.1 Stability
      5.3.2 Hazard resulting from break-up
      5.3.3 Tool holder and tool design
      5.3.4 Braking
      5.3.5 Devices to minimise the possibility or the effect
             of ejection
      5.3.6 Work-piece supports and guides
      5.3.7 Prevention of access to moving parts
  5.4 Protection against non-mechanical hazards
      5.4.1 Fire
      5.4.2 Noise
      5.4.3 Emission of chips and dust
      5.4.4 Electricity
      5.4.5 Ergonomics and handling
      5.4.6 Lighting
      5.4.7 Pneumatics
      5.4.8 Hydraulics
      5.4.9 Radiation
      5.4.10 Static electricity
      5.4.11 Errors of fitting
      5.4.12 Isolation
      5.4.13 Maintenance
6 Information for use
  6.1 Warning devices
  6.2 Marking
  6.3 Instruction handbook
Annex A (informative) Examples of safety related electronic
        control systems
Annex B (normative) Tool spindle dimensional tolerances
Annex C (normative) Operating conditions for noise emission
        measurement
      C.1 General
      C.2 Noise measurements
          C.2.1 Test conditions
          C.2.2 Microphone positions
          C.2.3 General data sheet
Annex D (informative) Safe working practice
Annexe ZA (informative) Relationship of this document with
          EC Directives
Bibliography

Describes all significant hazards, hazardous situations and events which are relevant to one side profiling machines with fixed table and feed rollers or feed chain.