NS EN 1288-1 : 1ED 2000

Foreword
1 Scope
2 Normative references
3 Definitions
4 Symbols
5 Factors to be taken into account when testing glass
      5.1 Glass as a material
      5.2 Bending stress and bending strength
      5.3 Type of glass
      5.4 Orientation of the specimens
      5.5 Number of specimens in a sample
6 Explanations of the test methods
      6.1 Coaxial double ring test for large test surface
             areas
      6.2 Test with specimen supported at two points
             (four point bending)
      6.3 Coaxial double ring test for small test surface
             areas
7 Range of application of the test methods
      7.1 General limitations
      7.2 Limitations to EN 1288-2
      7.3 Limitations to EN 1288-3
      7.4 Limitations to EN 1288-4
      7.5 Limitations to EN 1288-5
8 Calibration of the testing machines
9 Recommendations for safe use of test equipment
Annex A (informative) Bibliography

Defines the determination of the bending strength of monolithic glass for use in buildings. Insulating units or laminated glass testing is excluded from this standard. This standard describes: explanations of the reasons for designing different test methods; limitations to the test methods; consideration to be taken into account when testing glass, and gives pointers to safety requirement for the personnel operating the test equipment. Test methods in this standard are intended to provide large numbers of bending strength values that can be used as the basis for statistical evaluation of glass strength. Test methods are specified in detail in EN 1288-2, EN 1288-3, EN 1288-4, AND EN 1288-5.