NS EN 13706-2 : 1ED 2002

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
  4.1 Appearance
  4.2 Dimensional tolerance
  4.3 Workmanship
5 Sampling
  5.1 General
  5.2 Certificate of Conformity
  5.3 Resolution of quality issues
6 Preparation of plates and test specimens
  6.1 Manufacture of test plates
  6.2 Preparation of specimens
  6.3 Profile full section test specimens
7 List of Properties
8 Labelling
Annex A (normative) - Visual Defects: Description and
                        Acceptance Levels (see also Annex C -
                        Workmanship
Annex B (normative) - Dimensional tolerances for pultruded
                        profiles
Annex C (normative) - Workmanship
Annex D (normative) - Determination of effective flexural
                        modulus
Annex E (normative) - Determination of the pin bearing
                        strength
Annex F (informative) - Recommended test methods for
                        particular requirements
Annex G (informative) - Determination of flexural, shear and
                        torsional stiffness properties
Bibliography

Specifies the general requirements applicable to the specification of all types of pultruded profiles falling within the scope of this specification as defined in Part 1 of EN 13706 and also specifies the properties to be followed in the preparation of test specimens for the determination of mechanical properties required for the designation in Part 1 and the specific requirements in Part 3 of EN 13706.