NS EN 14188-1 : 1ED 2004

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification and specification
  4.1 Joint sealant
  4.2 Primer
5 Requirements
  5.1 Shelf life
  5.2 Compliance to requirements after safe heating temperature
  5.3 Softening point
  5.4 Density
  5.5 Cone penetration
  5.6 Penetration and recovery at +25 Degrees C (resilience)
  5.7 Heat stability
  5.8 Flow resistance
  5.9 Resistance to fuel immersion (solubility)
  5.10 Compatibility with asphalt pavements
  5.11 Bonding strength
  5.12 Cohesion
  5.13 Dangerous substances
6 Evaluation of conformity
  6.1 General
  6.2 Type Testing
       6.2.1 Initial Type Testing (ITT)
       6.2.2 Further Type Testing
  6.3 Factory Production Control (FPC)
       6.3.1 General
       6.3.2 Frequency of testing
       6.3.3 Equipment
       6.3.4 Raw materials and components
       6.3.5 Design process
       6.3.6 Non-conforming products
7 Marking, labelling and packaging
  7.1 General
  7.2 Hot applied joint sealant
  7.3 Primer
  7.4 Containers
Annex A (normative) Initial Type Testing and frequencies of
        testing for Factory Production Control
Annex B (informative) Example of a product data sheet
      B.1 General information
Annex ZA (informative) Clauses of this European Standard
         addressing essential requirements or other provisions
         of EU Directives
      ZA.1 Scope and relevant characteristics
      ZA.2 Procedure(s) for attestation of conformity
           ZA.2.1 Systems of attestation of conformity
           ZA.2.2 EC Certificate and declaration of conformity
      ZA.3 CE marking and labelling
Bibliography

Describes the requirements for hot-applied normal and fuel resistant joint sealants to be used in roads, airfields and other trafficked areas.