NS EN 15088 : 1ED 2006

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
  4.1 Ordering Information
  4.2 Selection of alloy and temper
  4.3 Product requirements
5 Evaluation of conformity
  5.1 General
  5.2 Testing
  5.3 Factory production control (FPC)
  5.4 One-off products, prototypes and products
      produced in very small quantities
6 Marking, labelling and packaging
Annex A (normative) Fatigue testing and design
        of extruded, rolled or forged products
        A.1 General
        A.2 Fatigue testing of the constituent
            material (extruded, rolled or forged
            products)
        A.3 Test piece for fatigue testing
        A.4 Design code
Annex B (normative) Bendability
        B.1 General
        B.2 Bendability classes
        B.3 Assignment to standardized tempers of
            semi-finished products
Annex ZA (informative) Clauses of this European
         Standard addressing the provisions of
         EU Construction Products Directive CPD
         - EU Directive 89/106/EEC
         ZA.1 Scope and relevant characteristics
         ZA.2 Procedures for the attestation of
              conformity of structural metallic
              construction products
         ZA.3 CE marking and labelling
Bibliography

Describes the requirements for semi-finished products and castings of aluminium and aluminium alloys for load-bearing structural construction works (Construction works covers building and civil engineering works).