NS EN 1943 : 2ED 2002

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Significance and use
5 Method A: Measurement of shear adhesion to a vertical
   standard steel panel
   5.1 Principle
   5.2 Materials
   5.3 Apparatus
   5.4 Test samples and test piece
   5.5 Procedure
   5.6 Expression of results
   5.7 Test report
6 Method B: Measurement of shear adhesion to a vertical
   panel covered with NIST SRM 1810A standard fibreboard
   6.1 Principle
   6.2 Materials
   6.3 Apparatus
   6.4 Test samples and test piece
   6.5 Procedure
   6.6 Expression of results
   6.7 Test report
7 Method C: Measurement of shear adhesion to a vertical
   panel covered with a fibreboard agreed upon by the buyer
   and the seller
   7.1 Principle
   7.2 Procedure
8 Method D: Measurement of shear adhesion of filament
   reinforced tape applied to a horizontal standard steel
   panel
   8.1 Principle
   8.2 Materials
   8.3 Apparatus
   8.4 Test samples and test piece
   8.5 Procedure
   8.6 Expression of results
   8.7 Test report
9 Method E: Measurement of shear adhesion of filament
   reinforced tape applied to a horizontal panel covered
   with NIST SRM 1810A standard fibreboard
   9.1 Principle
   9.2 Procedure
10 Method F: Measurement of shear adhesion of filament
   reinforced tape applied to a horizontal panel covered
   with a fibreboard agreed upon by the buyer and the seller
   10.1 Principle
   10.2 Procedure
11 Method G: Measurement of shear adhesion to a vertical
   standard steel panel at an elevated temperature after
   10 min dwell time
   11.1 Principle
   11.2 Procedure

Gives a method of measuring the force needed for an adhesive tape to slip in shear from a specified metal surface to which adhesive has been applied under test conditions and two different temperatures - 23 deg C and 70 deg C.