NS EN ISO 15085 : 2003 AMD 1 2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
   4.1 Functions of the working deck
   4.2 Means of protection
   4.3 Minimum width of decks
   4.4 Continuity of the working deck
5 Safety devices
6 Tables of requirements
   6.1 General
   6.2 Requirements for non-sailing boats
   6.3 Requirements for sailing boats
7 Specific requirement for slip-resistant areas
   7.1 General
   7.2 Requirements for trampolines and nets
8 Requirements for foot-stops
   8.1 General
   8.2 Provision of foot-stops
   8.3 Minimum foot-stop height and angle
   8.4 Foot-stops made of angled surfaces
   8.5 Maximum foot-stop clearance between deck and
        foot stop
   8.6 Continuity on the working deck level in the
        way of the foot-stop
   8.7 Gaps in the foot-stop rail
9 Requirements for handholds
   9.1 General
   9.2 Location in way of side decks
   9.3 Strength
10 Common requirements for low and high guard-rails
   and guard-lines
   10.1 General
   10.2 Height of guard-rails or guard-lines
   10.3 Intermediate lines, vertical spacing
   10.4 Risk of falling overboard from elevated parts
   10.5 Openings in guard-rails/guard-lines
   10.6 Bow pulpits for sailing boats
   10.7 Transom guard-rails/guard-lines for sailing boats
   10.8 Forward cross beams of sailing catamarans
   10.9 Central hull of sailing trimarans
11 Specific strength requirements for guard-rails or low
   guard-rails
12 Specific requirements for guard-lines
   12.1 Requirements for high guard-lines, low guard-lines
        and intermediate guard-lines
   12.2 Requirements for stanchions or guard-line supports
13 Requirements for hooking points
   13.1 General
   13.2 Location
   13.3 Size
   13.4 Strength
14 Attachment points for jack-lines
   14.1 General
   14.2 Fitting
   14.3 Strength
15 Body support on high-speedboats
   15.1 General
   15.2 Body support
16 Means of reboarding
17 Owner's manual
Bibliography

Defines the design as well as the construction and strength requirements for safety devices and arrangements intended to minimize the risk of falling overboard, and requirements to facilitate reboarding. Also defines the means which can be used individually or combined to achieve these objectives, and applies to small craft of up to 24 m length of hull.