PD CEN/TR 14549:2004

1 Scope
2 Normative References
3 Terms and definitions
4 General
  4.1 Scope of the PED
  4.2 Responsibilities
  4.3 Fluid groups
  4.4 Conformity assessment categories
  4.5 Conformity assessment procedures
  4.6 Hazard analysis
5 Materials
  5.1 Material selection and appraisal
  5.2 Material certification
6 Design and calculation
  6.1 Allowable stresses
  6.2 Joint coefficients
  6.3 Isolation
7 Fabrication and installation
  7.1 Permanent joining (e.g. Welding)
  7.2 Traceability
  7.3 Documentation
      7.3.1 Marking and labelling
      7.3.2 Operating instructions
      7.3.3 Marking at take-off points
      7.3.4 Declaration of conformity
8 Inspection and testing
  8.1 Non-destructive tests
  8.2 Final inspection
9 Safety devices
Annex A (informative) Checklist of major actions arising
        from the PED
Annex B (informative) Key articles in the PED
      B.1 Introduction
      B.2 Table of Key Articles in the PED
Annex C (informative) Clauses of this guide addressing essential
        requirements or other provisions of the PED
Annex D (informative) Comparison of ISO 15649, ANSI/ASME B31.3
        and PED annex I (Essential Safety Requirements)
      D.1 Introduction
      D.2 Comparison tables
          D.2.1 Contents of each table
          D.2.2 How to use the tables
Annex E (informative) Sources of further information and
        guidance
      E.1 Established guidelines
          E.1.1 General
          E.1.2 European Commission (CEC) guidelines
          E.1.3 Other guidelines
      E.2 Other sources of information
          E.2.1 Websites
          E.2.2 Published Guidance documents
          E.2.3 Miscellaneous sources
      E.3 Abbreviations

Defines a set of common additional and modified requirements to ISO 15649 and ANSI/ASME B31.3 necessitated by the PED. This Guide is intended for use in the petroleum, petrochemical and chemical industries.

This Guide is intended for use in the petroleum, petrochemical and chemical industries. It identifies and defines a set of common additional and modified requirements to ISO 15649 and ANSI/ASME B31.3 necessitated by the PED. Additional guidance is provided by a suite of annexes (A to E) which are intended to be read independently, but in the context of the main text. These include an actions checklist, tables identifying key requirements of the PED and the corresponding clauses of the ISO/ANSI–ASME standards, and supplementary information.

ISO 15649 incorporates ANSI/ASME B31.3 by normative reference and also contains additional common international practice. The relationships are illustrated in Figure 1.

NOTE The scope of the PED itself is defined therein, in particular in the Preamble and in Article 1.