PD CEN/TR 16596:2013
Current
The latest, up-to-date edition.
Electric-electronic interface between chassis-cab and bodywork of refuse collection vehicles (RCVs)
Hardcopy , PDF
English
30-11-2013
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Electric interface
5 CAN Interface
Annex A (normative) - Architecture of the
electric-electronic interface
Annex B (normative) - Plugs
Annex C (normative) - Pin-out and defined signals
Annex D (normative) - Characteristics of the engine
revolution signal
Annex E (normative) - Characteristics of the driving
speed signal
Annex F (normative) - Configuration of the information:
chassis ready
Annex G (normative) - Control of the beacon
Annex H (normative) - CAN messages transmitted by
bodywork
Annex I (normative) - CAN messages received by
bodywork
Bibliography
Recommends a standardized interface between the chassis-cab and the bodywork of refuse collection vehicles.
| Committee |
B/183
|
| DocumentType |
Standard
|
| Pages |
78
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
This Technical Report proposes a standardized interface between the chassis -cab and the bodywork of refuse collection vehicles. The solution, initially for vehicles with hard wired interface and CAN interface, is developed into full CAN communication between the bodywork and the chassis -cab.
| Standards | Relationship |
| CEN/TR 16596:2013 | Identical |
| EN 1501-2:2005+A1:2009 | Refuse collection vehicles and associated lifting devices - General requirements and safety requirements - Part 2: Side loaded refuse collection vehicles |
| EN 1501-5:2011 | Refuse collection vehicles - General requirements and safety requirements - Part 5: Lifting devices for refuse collection vehicles |
| EN 1501-3:2008 | Refuse collection vehicles and their associated lifting devices - General requirements and safety requirements - Part 3: Front loaded refuse collection vehicles |
| EN 1501-1:2011+A1:2015 | Refuse collection vehicles - General requirements and safety requirements - Part 1: Rear loaded refuse collection vehicles |
| SAE J1939/71_201610 | Vehicle Application Layer |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.