PD CEN/TS 16637-3:2016

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Principle
6 Reagents
7 Equipment
8 Sample preparation
9 Test procedure
10 Evaluation of measurement results
11 Documentation and test report
12 Test performance
13 Indirect methods
Annex A (informative) - Examples for sample preparation
        procedure
Annex B (informative) - Illustration of the column and
        accompanying equipment
Annex C (normative) - Procedures for packing and
        saturation of the column
Annex D (informative) - Assessment of release
        mechanism(s)
Bibliography

Defines an Up-flow Percolation Test (PT) which is applicable to determine the leaching beha iour of inorganic and non- olatile organic substances from granular construction products.

(1) This Technical Specification specifies an Up-flow Percolation Test (PT) which is applicable to determine the leaching behaviour of inorganic and non-volatile organic substances from granular construction products. The test is not suitable for substances that are volatile under ambient conditions. The construction products are subjected to percolation with water as a function of liquid to solid ratio under specified percolation conditions. The method is a once-through column leaching test. (2) This up-flow percolation test is performed under specified test conditions for construction products and does not necessarily produce results that mimic specific intended use conditions. This test method produces eluates, which can subsequently be characterized by physical, chemical and ecotoxicological methods according to existing standard methods. The results of eluate analysis are presented as a function of the liquid/solid ratio. The test results enable the distinction between different leaching behaviour. NOTE1 Volatile organic substances include the low molecular weight substances in mixtures such as mineral oil. NOTE2 It is not always possible to adjust test conditions simultaneously for inorganic and organic substances and test conditions may also vary between different groups of organic substances. Test conditions for organic substances are generally more stringent than those for inorganic substances. The test conditions are generally described in a way that they fit testing organic substances and are also applicable to inorganic substances depending on the set-up. NOTE3 For ecotoxicity testing, eluates representing the release of both inorganic and organic substances are needed. In this document, ecotoxicological testing is meant to include also genotoxicological testing. Construction products that exhibit a saturated hydraulic conductivity of about 10 - 8 m/s or higher can usually be subjected to this test. This procedure is also applicable to materials showing solidification in the column, if the final hydraulic conductivity is within the specified range. Inert granular material should not be added to improve permeability in order to enable their testing. NOTE4 This procedure is generally not applicable to products that are easily biologically degradable and products reacting with the leachant, leading, for example, to excessive gas emission or excessive heat release, impermeable hydraulically bound products or products that swell in contact with water.