PD IEC/TS 62743:2012

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions, abbreviations
   and symbols, quantities and units
4 General test procedure
5 General requirements
6 Radiation detection requirements
7 Environmental requirements
8 Mechanical requirements
9 Electromagnetic requirements
10 Documentation
Annex A (informative) - Parameter values
        for typical workplaces where
        pulsed radiation occurs
Annex B (informative) - Parameters
        characterizing the pulsed
        radiation field
Bibliography

Pertains to all types of counting dosemeters, irrespective of the measuring quantity and the type of radiation intended to be measured.

This Technical Specification applies to all types of counting dosemeters, irrespective of the measuring quantity and the type of radiation intended to be measured. It ensures that a single radiation pulse can be correctly measured even if the dosemeter is in the internal state relevant for measuring background or environmental radiation. The characteristics of the dosemeter for repeated pulses is expected to be better than for one single radiation pulse with the same parameters but worse than for continuous radiation, i.e., in between of the characteristics for these two extreme conditions. This Technical Specification does not specify the characteristics of the dosemeter for repeated pulses. The Technical Specification does not apply for those types of counting dosemeters that either

• do not have an indication or software read-out of the dose rate and the number of pulses counted,

• convert the non-pulsed detector signal to counts by a converter, or

• use nuclear reactions to generate long and nearly continuous secondary radiation fields which then are measured by the dosemeter using counting techniques instead of measuring the direct radiation pulse.

The pulsed radiation source is characterized by the parameters

• radiation pulse duration, t_pulse,

• pulse peak dose rate, H_{pulse, peak} ,

• dose per radiation pulse, H_pulse.

This Technical Specification considers the pulsation of the radiation field as an additional influence quantity like particle energy and direction of radiation incidence. Therefore, the tests described are additional to all the tests in the respective standards.

This technical specification describes methods to determine the characteristic parameters of the counting dosemeter. A prerequisite of the method is that the model function of the dose-meter can sufficiently be approximated by

This simplified model function should not fully describe the dosemeter but it should be valid only – maybe with effective values – for the tests in the case of a single pulse occurring when the dosemeter is in the internal state relevant for measuring background or environmental radiation, i.e., the dosemeter has not performed any specific parameter adjustment for high dose rate. In this sense this simplified model function uses effective parameters specific for pulsed radiation.

This technical specification is applicable to all types of radiation for which a suitable pulsed reference field is available and all other requirements are fulfilled.