PD ISO/TS 11665-13:2017
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Measurement of radioactivity in the environment. Air: radon 222 Determination of the diffusion coefficient in waterproof materials: membrane two-side activity concentration test method
Hardcopy , PDF
English
25-10-2017
09-12-2025
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Principle of the test method
5 Measuring system
6 Test methods
7 General application procedures
8 Influence quantities
9 Expression of results
10 Quality management and calibration of the test device
11 Test report
Annex A (informative) - Determining the radon diffusion
coefficient during the phase of stationary radon
diffusion according to method C
Annex B (informative) - Determining the radon diffusion
coefficient during the phase of non-stationary radon
diffusion
Bibliography
Describes the different methods intended for assessing the radon diffusion coefficient in waterproofing materials such as bitumen or polymeric membranes, coatings or paints, as well as assumptions and boundary conditions that shall be met during the test.
| Committee |
NCE/2
|
| DocumentType |
Standard
|
| Pages |
46
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
This document specifies the different methods intended for assessing the radon diffusion coefficient in waterproofing materials such as bitumen or polymeric membranes, coatings or paints, as well as assumptions and boundary conditions that shall be met during the test.
This document is not applicable for porous materials, where radon diffusion depends on porosity and moisture content.
| Standards | Relationship |
| ISO/TS 11665-13:2017 | Identical |
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| ISO 11665-1:2012 | Measurement of radioactivity in the environment — Air: radon-222 — Part 1: Origins of radon and its short-lived decay products and associated measurement methods |
| ISO 11665-5:2012 | Measurement of radioactivity in the environment — Air: radon-222 — Part 5: Continuous measurement method of the activity concentration |
| IEC 61577-2:2014 | Radiation protection instrumentation - Radon and radon decay product measuring instruments - Part 2: Specific requirements for <sup>222</sup>Rn and <sup>220</sup>Rn measuring instruments |
| ISO 11929:2010 | Determination of the characteristic limits (decision threshold, detection limit and limits of the confidence interval) for measurements of ionizing radiation — Fundamentals and application |
| ISO 11665-6:2012 | Measurement of radioactivity in the environment — Air: radon-222 — Part 6: Spot measurement method of the activity concentration |
| ISO/IEC Guide 98-3:2008 | Uncertainty of measurement — Part 3: Guide to the expression of uncertainty in measurement (GUM:1995) |
| ISO 80000-10:2009 | Quantities and units — Part 10: Atomic and nuclear physics |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.