PREN 1124-4 : DRAFT 2012
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PIPES AND FITTINGS OF LONGITUDINALLY WELDED STAINLESS STEEL PIPES WITH SPIGOT AND SOCKET FOR WASTEWATER SYSTEMS - PART 4: COMPONENTS FOR VACUUM DRAINAGE SYSTEMS AND FOR DRAINAGE SYSTEMS ON SHIPS
01-10-2013
12-01-2013
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Pipes and fittings requirements
6 Dimensions
7 Testing
8 Assessment of conformity
Describes requirements, dimensions and tolerances for pipes and fittings of longitudinally welded, stainless steel pipe with spigot and socket used for vacuum drainage systems inside and outside buildings and for gravity and vacuum drainage systems on ships and floating maritime structures.
| Committee |
TC 165
|
| DocumentType |
Draft
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| 12/30256801 DC : DRAFT FEB 2012 | Identical |
| ISO 15749-2:2004 | Ships and marine technology — Drainage systems on ships and marine structures — Part 2: Sanitary drainage, drain piping for gravity systems |
| EN 1124-3:2008 | Pipes and fittings of longitudinally welded stainless steel pipes with spigot and socket for waste water systems - Part 3: System X - Dimensions |
| ISO 15749-3:2004 | Ships and marine technology — Drainage systems on ships and marine structures — Part 3: Sanitary drainage, drain piping for vacuum systems |
| EN ISO 15749-3:2004 | Ships and marine technology - Drainage systems on ships and marine structures - Part 3: Sanitary drainage, drain piping for vacuum system (ISO 15749-3:2004) |
| EN 12109:1999 | Vacuum drainage systems inside buildings |
| EN ISO 15749-2:2004 | Ships and marine technology - Drainage systems on ships and marine structures - Part 2: Sanitary drainage, drain piping for gravity system (ISO 15749-2:2004) |
| EN 10226-1:2004 | Pipe threads where pressure tight joints are made on the threads - Part 1: Taper external threads and parallel internal threads - Dimensions, tolerances and designation |
| EN 1124-2:2014 | Pipes and fittings of longitudinally welded stainless steel pipes with spigot and socket for waste water systems - Part 2: System S, forms and dimensions |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.