PREN 13022-2 : DRAFT 2003

Foreword
1 Scope
2 Normative references
3 Definitions
4 Sealant
  4.1 General
  4.2 The compulsory part of the product description
5 Requirements
  5.1 General
  5.2 Identification tests
  5.3 Intrinsic properties
  5.4 Environmental influences
  5.5 Water vapour transmission and gas transmission
  5.6 Reaction to fire
  5.7 Dangerous substances
  5.8 Sealant category differentiation
6 Sealing and bonding
7 Compatibility with adjacent material
8 Evaluation of conformity
  8.1 General
  8.2 Initial type testing of the product (8.1, c)
  8.3 Factory production control and inspection of samples in
      accordance with a prescribed test plan (8.1, a and b)
  8.4 Initial inspection of factory and of factory production
      control (8.1, d)
  8.5 Continuous surveillance and assessment of the factory
      production construction Products Directive
9 Marking and labelling
  9.1 General
  9.2 Labelling
  9.3 The "characteristic/performance identification paper"
Annex A (normative) Evaluation of test results
        A.1 Evaluation of the characteristics values R[u,5]
        A.2 Evaluation of the rigidity modulus at the origin
        A.3 Secant modulus, tangent modulus and shear modulus
        A.4 Example of the determination of the rigidity modulus
Annex B (normative) Shear at 23 degree C
Annex C (normative) Factory production control
        C.1 Factory Production Control Requirements
        C.2 Marking
        C.3 Inspection and testing tables of ultra-violet resistance
            sealant and structural sealant
Annex D (normative) Thin layer seal category differentiation
        D.1 General
        D.2 Test specimens and test samples
        D.3 Conditioning sequence
        D.4 Category differentiation
Annex E (informative) Formation of bubbles
Annex F (informative) Sealing, structural bonding and UV resistance
        schematic illustrations
Annex G (normative) Initial testing of bonding of sealant to
        not glass substrates
        G.1 Bonding to coated surfaces of coated glass
        G.2 Metals
        G.3 Test specimens
        G.4 Description of the material
        G.5 Mechanical strength and adhesion: Initial testing
        G.6 Classification
        G.7 Test report
        G.8 Initial testing of specific projects
Annex V (informative) Provisions for voluntary third party involvement
        V.1 Clauses of this European standard addressing possible
            provisions of voluntary third parties
        V.2 Tasks of voluntary third parties when contracted to be
            involved
        V.3 Voluntary marking and labelling
Annex ZA (informative) Provisions of EU Construction Products
         Directive
         ZA.1 Clauses of this European Standard addressing the
              provisions of EU Construction Products Directive
         ZA.2 Procedure(s) for the attestation of conformity of
              products
         ZA.3 CE Marking and labelling

Describes the evaluation of conformity and the factory production control of sealant for the intrinsic capabilities. Also specifies requirements for seals and bonds of sealant.