PREN 1366-4 : DRAFT 2003

Foreword
Introduction
Caution
1 Scope
2 Normative references
3 Definitions
4 Test equipment
5 Test conditions
   5.1 Heating conditions
   5.2 Pressure conditions
6 Test specimen
   6.1 General
   6.2 Size
   6.3 Number of test specimens
7 Installation of test specimen
   7.1 General
   7.2 Supporting construction
   7.3 Test construction
   7.4 Splice locations
   7.5 Induced movement
8 Conditioning
9 Application of instrumentation
   9.1 General
   9.3 Deformation and deflection
   9.4 Integrity measurement
10 Test procedure
   10.1 General
   10.2 Installation of test construction
   10.3 Mechanically induced movement of the test specimen
   10.4 Measurements and observations
11 Performance criteria
   11.1 Insulation
   11.2 Integrity
   11.3 Expression of results
12 Test report
13 Field of direct application of test results
   13.1 General
   13.2 Supporting construction
   13.3 Seal position
   13.4 Mechanically induced movement
   13.5 Width of the linear joint seal
Annex A (normative) Standard condition for linear joint
                    seals with no mechanically induced
                    relative movement of the joint faces
   A.1 Standard condition
   A.2 Test procedure
Annex B (normative) Standard condition for linear joints seals
                    with mechanically induced movement of the
                    joint faces
   B.1 General
   B.2 Standard condition(s)
   B.3 Conditions for other movements

Specifies a method for determining the fire resistance of linear joint seals based on their intended end use.