SAE AMS2201J
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
TOLERANCES Aluminum and Aluminum Alloy Bar, Rod, Wire, and Forging Stock Rolled or Drawn
Hardcopy , PDF
01-10-1982
English
15-05-1973
Important note : Users cannot be edited or removed once added to your Multi user PDF.| DocumentType |
Standard
|
| Pages |
12
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy |
This specification covers established manufacturing tolerances applicable to aluminum-base alloy rolled or drawn bar, rod, wire, and forging stock. These tolerances apply to all conditions, unless otherwise noted. The term \"excl\" applies only to the higher figure of the specified range. The general temper designation \"-TX51\" is used for brevity and denotes the full temper designations -T351, -T451, -T651, -T851, and -T7351, the \"X\" representing one or more digits preceding the \"51\". Dimensions in U.S. conventional units are primary; dimensions in SI units are shown as the equivalent of the inch/foot/degree dimensions and are not to be construed as standard for product produced to SI dimensions.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.