SAE AMS2759/2F
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Heat Treatment of Low-Alloy Steel Parts Minimum Tensile Strength 220 ksi (1517 MPa) and Higher
Hardcopy , PDF
English
23-04-2014
06-05-2018
1. SCOPE
2. APPLICABLE DOCUMENTS
3. TECHNICAL REQUIREMENTS
4. QUALITY ASSURANCE PROVISIONS
5. PREPARATION FOR DELIVERY
6. ACKNOWLEDGMENT
7. REJECTIONS
8. NOTES
Specifies requirements for heat treatment of low-alloy steel parts to minimum ultimate tensile strengths of 220 ksi (1517 MPa) and higher.
| DocumentType |
Standard
|
| Pages |
13
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This specification, in conjunction with the general requirements for steel heat treatment covered in AMS2759, establishes the requirements for heat treatment of low-alloy steel parts to minimum ultimate tensile strengths of 220 ksi (1517 MPa) and higher. Parts are defined in AMS2759.
| SAE AMS2759E | Heat Treatment of Steel Parts General Requirements |
| NASA STD 5005(INT) : 2007 | THE DESIGN AND FABRICATION OF GROUND SUPPORT EQUIPMENT |
| SAE AMS2759/6B | Gas Nitriding and Heat Treatment of Low-Alloy Steel Parts |
| SAE AMS3054C | Oil, Lubricating, Low Temperature For -55 °C (-67 °F) Service |
| SAE AMS2418J | Plating, Copper |
| SAE AMS2759E | Heat Treatment of Steel Parts General Requirements |
| SAE AMS2750E | Pyrometry |
| SAE AMS2769B | Heat Treatment of Parts in a Vacuum |
| SAE AMS2759/11 | Stress Relief of Steel Parts |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.