SAE AMS4459A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Aluminum Alloy, Extrusion 2.7Cu - 1.8Li - 0.7Zn - 0.3Mn - 0.3Mg - 0.08Zr (2099-T81) Solution Heat Treated, Stress Relieved by Stretching 1 to 3% and Aged
28-10-2019
03-01-2013
1. SCOPE
2. APPLICABLE DOCUMENTS
3. TECHNICAL REQUIREMENTS
4. QUALITY ASSURANCE PROVISIONS
5. PREPARATION FOR DELIVERY
6. ACKNOWLEDGEMENT
7. REJECTIONS
8. NOTES
Describes an aluminum alloy in the form of extruded bars, rods, and profiles (shapes) produced with cross sectional area of 22.5 square inches (145 cm[2]) maximum and a circumscribing circle diameter (circle size) of 17.4 inches (44.2 cm) maximum.
| DocumentType |
Standard
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This specification covers an aluminum alloy in the form of extruded bars, rods, and profiles (shapes) produced with cross sectional area of 22.5 square inches (145 cm2x) maximum and a circumscribing circle diameter (circle size) of 17.4 inches (44.2 cm) maximum. See 8.3 for definition of circumscribing circle size.
| SAE AS85421A | Fittings, Tube, Fluid Systems, Separable, Beam Seal, 3000/4000 psi, General Specification For |
| ANSI H35.2 : 2017 | DIMENSIONAL TOLERANCES FOR ALUMINUM MILL PRODUCTS |
| ASTM B 666/B666M : 2015 : REDLINE | Standard Practice for Identification Marking of Aluminum and Magnesium Products |
| ASTM G 85 : 2011 : REDLINE | Standard Practice for Modified Salt Spray (Fog) Testing |
| SAE AMS2772G | Heat Treatment of Aluminum Alloy Raw Materials |
| SAE AS1990D | Aluminum Alloy Tempers |
| SAE AMS2355L | Quality Assurance, Sampling and Testing Aluminum Alloys and Magnesium Alloy Wrought Products (Except Forging Stock), and Rolled, Forged, or Flash Welded Rings |
| ASTM E 1004 : 2017 : REDLINE | Standard Test Method for Determining Electrical Conductivity Using the Electromagnetic (Eddy Current) Method |
| ASTM B 660 : 2015 : REDLINE | Standard Practices for Packaging/Packing of Aluminum and Magnesium Products |
| ANSI H35.2M : 2013 | DIMENSIONAL TOLERANCES FOR ALUMINUM MILL PRODUCTS (METRIC) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.