SAE AMS6488H
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Steel, Bars and Forgings 5.0Cr - 1.3Mo - 0.5V - (0.38 - 0.43C)
Hardcopy , PDF
English
16-01-2008
16-01-2008
1 SCOPE
2 APPLICABLE DOCUMENTS
3 TECHNICAL REQUIREMENTS
4 QUALITY ASSURANCE PROVISIONS
5 PREPARATION FOR DELIVERY
6 ACKNOWLEDGEMENT
7 REJECTIONS
8 NOTES
Covers a low-alloy steel in the form of bars, forgings, and forging stock.
| DocumentType |
Standard
|
| Pages |
9
|
| PublisherName |
SAE International
|
| Status |
Withdrawn
|
| Supersedes |
This specification covers a low-alloy steel in the form of bars, forgings, and forging stock.These products have been used typically for parts requiring a steel capable of through-hardening to a minimum hardness of 50 HRC in section thicknesses up to 12 inches (305 mm) with relatively high levels of strength, fatigue resistance, ductility, and thermal stability in service from -100 degrees to +1000 degrees F (-73 degrees to +538 degrees C), but usage is not limited to such applications.Certain design and processing procedures may cause these products to become susceptible to stress-corrosion cracking after heat treatment; SAE ARP 1110 recommends practices to minimize such conditions.
| SAE AMS7464D | Bolts and Screws, Steel, Low-Alloy Heat Resistant 222,000 psi (1517 MPa) Tensile Strength Hardened and Tempered, Roll Threaded |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.