SAE ARP1307B
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Measurement of Exterior Noise Produced by Aircraft Auxiliary Power Units (APUs) and Associated Aircraft Systems During Ground Operation
Hardcopy , PDF
30-05-2024
English
09-04-2013
Important note : Users cannot be edited or removed once added to your Multi user PDF.
INTRODUCTION
1. SCOPE
2. APPLICABLE DOCUMENTS
3. GENERAL CONDITIONS
4. INSTRUMENTATION
5. TEST PROCEDURE
6. DATA REPORTING
7. NOTES
Defines measuring noise at specific receiver locations (passenger and cargo doors, and servicing positions) and for conducting general noise surveys around aircraft.
| DocumentType |
Standard
|
| Pages |
12
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
Test procedures are described for measuring noise at specific receiver locations (passenger and cargo doors, and servicing positions) and for conducting general noise surveys around aircraft. Procedures are also described for measuring noise level and directivity at noise source locations to facilitate the understanding and interpretation of the data.Requirements are identified with respect to instrumentation; acoustic and atmospheric environment; data acquisition, reduction and presentation, and such other information as is needed for reporting the results.This document makes no provision for predicting APU or component noise from basic engine characteristics or design parameters, nor for measuring noise of more than one aircraft operating at the same time.No attempt is made to suggest acceptable levels of noise or suitable subjective criteria for judging acceptability. ICAO Annex 16 Volume I Attachment C provides guidance on recommended maximum noise levels.
| SAE ARP 217 D : 2016 | TESTING OF AIRPLANE INSTALLED ENVIRONMENTAL CONTROL SYSTEMS (ECS) |
| SAE AIR 1826 : 2016 | ACOUSTICAL CONSIDERATIONS FOR AIRCRAFT ENVIRONMENTAL CONTROL SYSTEM DESIGN |
| ANSI/ASA S1.1:2013 | ACOUSTICAL TERMINOLOGY |
| ANSI S1.4 : 1983 | SPECIFICATION FOR SOUND LEVEL METERS |
| ANSI S1.11 : 2014 | SPECIFICATION FOR OCTAVE-BAND AND FRACTIONAL-OCTAVE-BAND ANALOG AND DIGITAL FILTERS |
| IEC 60942:2003 | Electroacoustics - Sound calibrators |
| ISO 266:1997 | Acoustics — Preferred frequencies |
| IEC 61265:1995 | Electroacoustics - Instruments for measurement of aircraft noise - Performance requirements for systems to measure one-third-octave-band sound pressure levels in noise certification of transport-category aeroplanes |
| ANSI/ASA S1.6 : 2016 | PREFERRED FREQUENCIES AND FILTER BAND CENTER FREQUENCIES FOR ACOUSTICAL MEASUREMENTS |
| ISO 1683:2015 | Acoustics Preferred reference values for acoustical and vibratory levels |
| IEC 61094-2:2009 | Electroacoustics - Measurement microphones - Part 2: Primary method for pressure calibration of laboratory standard microphones by the reciprocity technique |
| ANSI/ASA S1.8 : 2016 | REFERENCE VALUES FOR LEVELS USED IN ACOUSTICS AND VIBRATIONS |
| IEC 61260:1995 | Electroacoustics - Octave-band and fractional-octave-band filters |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.