SAE J2124_199810
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Numbering System for Single Diameter and Taper Reamers
Hardcopy , PDF
19-10-2019
English
14-10-1998
Gives a systematic procedure for identifying single diameter and taper reamers, intended for help with cataloging and supplying such tools.
DocumentType |
Standard
|
Pages |
16
|
PublisherName |
SAE International
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
This SAE Recommended Practice provides a systematic method for the identification of single diameter and taper reamers. It is intended to assist in the cataloging and supplying of these tools.NOTE 1— Caution must be taken when assigning codes for designators to prevent specifying reamers that cannot be physically or economically manufactured.NOTE 2— The Code Number coming from the manufacturer MUST reflect the actual tool construction.NOTE 3— In particular without limitation, SAE disclaims all responsibility for the accuracy or completeness of information contained within this report if the standards of this report are retrieved, combined, or used in connection with any software.
DIN 205:1996-12 | HAND REAMERS FOR METRIC TAPERS |
ISO 2250:2017 | Finishing reamers for Morse and metric tapers, with cylindrical shanks and Morse taper shanks |
ISO 3465:1975 | Hand taper pin reamers |
DIN 217:1972-09 | ARBORS WITH MORSE TAPER FOR SHELL REAMERS AND SHELL DRILLS |
ISO 4203:1978 | Parallel shank tools — Driving tenons and sockets — Dimensions |
DIN 204:1996-12 | HAND REAMERS FOR MORSE TAPERS |
ISO 5420:1983 | Reamers — Terms, definitions and types |
ISO 521:2011 | Machine chucking reamers with cylindrical shanks and Morse taper shanks |
DIN 10:2009-12 | SQUARES OF PARALLEL SHANKS FOR ROTATING TOOLS |
ISO 3466:2016 | Machine taper pin reamers with parallel shanks |
ISO 296:1991 | Machine tools — Self-holding tapers for tool shanks |
DIN 9:1996-12 | HAND TAPER PIN REAMERS |
DIN 209:1979-08 | MACHINE REAMERS WITH SCREWED - ON BLADES |
ISO 522:1975 | Special tolerances for reamers |
ISO 2401:1972 | Covered electrodes Determination of the efficiency, metal recovery and deposition coefficient |
ISO 3467:2016 | Machine taper pin reamers with Morse taper shanks |
DIN 1862:1962-01 | END MILL REAMERS FOR JIG BORING MACHINES |
ISO 236-1:1976 | Hand reamers |
DIN 311:1975-03 | BRIDGE REAMERS WITH MORSE TAPER SHANK |
ISO 2238:2011 | Machine bridge reamers |
ISO 236-2:2013 | Reamers — Part 2: Long fluted machine reamers with Morse taper shanks |
ISO 5413:1993 | Machine tools Positive drive of Morse tapers |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.