• Shopping Cart
    There are no items in your cart

SAE J1121_201608

Current

Current

The latest, up-to-date edition.

Helical Compression and Extension Spring Terminology

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

02-08-2016

€121.68
Excluding VAT

1. Scope
2. References
3. Hot Coiled Springs
4. Cold Wound Springs
5. Notes

The following recommended practice has been developed to assist engineers and designers in the preparation of specifications for the major types of helical compression and extension springs.

DocumentType
Standard
Pages
19
ProductNote
This standard is stabilized now
PublisherName
SAE International
Status
Current
Supersedes

The following recommended practice has been developed to assist engineers and designers in the preparation of specifications for the major types of helical compression and extension springs. It is restricted to a concise presentation of items which will promote an adequate understanding between spring manufacturer and spring user of the major practical requirements in the finished spring. Closer tolerances are obtainable where greater accuracy is required and the increased cost is justified.For the basic concepts underlying the spring design and for many of the details, see the SAE Information Report MANUAL ON DESIGN AND APPLICATION OF HELICAL AND SPIRAL SPRINGS, SAE HS 795, which is available from SAE Headquarters in Warrendale, PA 15096. A uniform method for specifying design information is shown in the TYPICAL DESIGN CHECK LISTS FOR HELICAL SPRINGS, SAE J1122.Two types of helical springs are considered:aHot coiled compression springs for general automotive use as well as for motor vehicle suspensions.bCold wound compression and extension springs for general automotive use.This recommended practice uses SI (metric) units in accordance with the provisions of SAE TSB 003.

SAE J1122_201608 Helical Springs: Specification Check Lists

SAE J230_201604 Stainless Steel, SAE 30302, Spring Wire and Springs
SAE J1122_201608 Helical Springs: Specification Check Lists
SAE J217_201604 Stainless Steel 17-7 PH Spring Wire and Springs
SAE J461_200212 Wrought and Cast Copper Alloys
SAE HS 84 : 2001 MANUAL ON SHOT PEENING
SAE TSB003_199905 Rules for SAE Use of SI (Metric) Units

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.