SAE J1401_201302
Current
The latest, up-to-date edition.
Road Vehicle - Hydraulic Brake Hose Assemblies for Use With Nonpetroleum-Base Hydraulic Fluids
05-02-2013
1. SCOPE
2. REFERENCES
3. DEFINITIONS
4. PERFORMANCE TESTS
5. PERFORMANCE REQUIREMENTS
6. CONSTRUCTION
7. HOSE IDENTIFICATION
8. NOTES
APPENDIX A - HOSE MANUFACTURER IDENTIFICATION CODE-COLORED
YARN ASSIGNMENTS AS OF DECEMBER 1998
This SAE Standard specifies the performance tests and requirements for hydraulic brake hose assemblies used in the hydraulic braking system of a road vehicle.
| DocumentType |
Standard
|
| PublisherName |
SAE International
|
| Status |
Current
|
| Supersedes |
This SAE Standard specifies the performance tests and requirements for hydraulic brake hose assemblies used in the hydraulic braking system of a road vehicle. It also specifies the methods used for identification of the hose manufacturer.This document applies to brake hose assemblies made of a hose fabricated from yarn and natural or synthetic elastomers and assembled with metal end fittings for use with nonpetroleum-base brake fluids as specified in SAE J1703, SAE J1704 and SAE J1705.The nominal internal diameter of the brake hose shall fall within one of the following values:aless than 4 mm (1/8 in or less)b4 to 5 mm (3/16 in)
| SAE J2552_201406 | Push-On Hose and Mating Hose Fittings |
| SAE J1288_201207 | Packaging, Storage, and Shelf Life of Hydraulic Brake Hose Assemblies |
| BIS IS 7079 : 2008(R2017) | AUTOMOTIVE VEHICLES - BRAKE HOSE ASSEMBLIES FOR HYDRAULIC BRAKING SYSTEMS USES WITH NON-PETROLEUM BASE BRAKE FLUID - SPECIFICATION |
| SAE J2593_201502 | Information Report for the Installation of Fluid Conductors and Connectors |
| SAE J1402_201710 | Automotive Air Brake Hose and Hose Assemblies |
| SAE J2545_201406 | Test Procedures for Non-SAE Hydraulic Hoses |
| MIL PRF 13719 : E | HOSE ASSEMBLY, RUBBER, HYDRAULIC BRAKE |
| SAE J517_201710 | Hydraulic Hose |
| SAE ARP1247E | Aircraft Ground Support Equipment – General Requirements |
| MIL-DTL-13719 Revision G:2012 | HOSE AND HOSE ASSEMBLY, RUBBER, HYDRAULIC BRAKE, TYPE 1 AND TYPE 2 |
| SAE J1705_200707 | Low Water Tolerant Brake Fluids |
| ISO/R 147:1960 | Load calibration of testing machines for tensile testing of steel |
| SAE J1704_201607 | Motor Vehicle Brake Fluid Based Upon Glycols, Glycol Ethers and the Corresponding Borates |
| SAE J1406_201207 | Application of Hydraulic Brake Hose to Motor Vehicles - Wheel End and Axle |
| ISO 3996:1995 | Road vehicles — Brake hose assemblies for hydraulic braking systems used with non-petroleum-base brake fluid |
| SAE J1703_201607 | Motor Vehicle Brake Fluid |
| SAE J1288_201207 | Packaging, Storage, and Shelf Life of Hydraulic Brake Hose Assemblies |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.