SAE J1742_200512
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Connections for High Voltage On-Board Road Vehicle Electrical Wiring Harnesses—Test Methods and General Performance Requirements
Hardcopy , PDF
24-03-2010
English
01-12-2005
DocumentType |
Standard
|
Pages |
24
|
PublisherName |
SAE International
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
Procedures included within this specification are intended to cover performance testing at all phases of development, production, and field analysis of electrical terminals, connectors, and components that constitute the electrical connection systems in high power (20 V to 600 V and/or >80 amps) road vehicle applications. These procedures are applicable only to terminals used for In-Line, Header, and Device Connectors and for cable sizes up to 120 mm2x (4/0).In cases where power levels are mixed in the same connector, (i.e. sensing or normal 14.5 volt system circuits with High Power Contacts) the High Power Contacts must pass J1742 requirements, and all other contacts must pass SAE J2223-2 requirements. The connection system (housing and high power contacts) shall meet J1742 requirements.The requirements and procedures in this document are not intended for connections internal to electrical/electronic modules or complete subassemblies.This document does not contain a test for EMI/EMC since these parameters must be tested as a combination of cable and connector. These are considered system level requirements. Determination of the need and type of test must be considered at that level.See Appendix C, Design Notes for further information.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.