SAE J1806_201708
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Clutch Dimensions for Truck and Bus Applications
Hardcopy , PDF
English
14-08-2017
10-05-2019
1. Scope
2. References
3. Definitions
4. Technical Requirements
5. Notes
Defines clutch dimensions to promote standardization of single-plate and two-plate pull type clutches.
| DocumentType |
Standard
|
| Pages |
10
|
| ProductNote |
This standard is now stabilized
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
Although not limited to, these clutches are normally used on trucks considered as Medium-Duty (Class 6 and 7), as well as Heavy-Duty (Class 8).
| SAE J373_201205 | Housing Internal Dimensions for Single- and Two-Plate Spring-Loaded Clutches |
| SAE J1479_201211 | Automotive Pull-Type Clutch Terminology |
| SAE J1857_200304 | Flywheel Dimensions for Truck and Bus Applications |
| SAE J617_201404 | Engine Flywheel Housing and Mating Transmission Housing Flanges |
| SAE J1731_200106 | Pilot Bearings for Truck and Bus Applications |
| SAE J1463_201211 | Pull-Type Clutch Transmission Installation Dimensions |
| SAE J2407_199710 | Clutch Installation and Release Linkage Requirements for Truck and Bus Application |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.