SAE J2223/2_201102

1 Scope
  1.1 Rationale
2 References
  2.1 Document Hierarchy
  2.2 Part Drawing
  2.3 Product Design Specification
  2.4 Test Request/Order
  2.5 Other Referenced Documents
3 Definitions and Abbreviations
  3.1 Definitions
  3.2 Abbreviations
4 General Requirements
  4.1 General
  4.2 Record Retention
  4.3 Sample Documentation
  4.4 Sample Size
  4.5 Default Test Tolerances
  4.6 Test Default Conditions
  4.7 Equipment
  4.8 Measurement Resolution
  4.9 Test Repeatability and Calibration
  4.10 Conformance Determination
  4.11 Disposition of Samples
  4.12 Part Endurance
5 Test and Acceptance Requirements
  5.1 General
  5.2 Terminal - Mechanical Tests
  5.3 Terminal - Electrical Tests
  5.4 Connector - Mechanical Tests
  5.5 Connector - Electrical Tests
  5.6 Connector Environmental Tests
  5.7 Special Tests
  5.8 Severe Duty Tests
  5.9 Test Sequence
6 Notes
  6.1 Marginal Indicia
Appendix A Tests Recommended for New Tooling, Tool Transfer,
           or Material Change
Appendix B Tests for New/Existing Terminal or Connector Designs
Appendix C Source List
Appendix D Design Notes

Covers performance testing at all phases of development, production, and field analysis of electrical terminals, connectors, and components that constitute the electrical connection systems in low voltage (0-20 VDC) road vehicle applications.

Procedures included within this specification are intended to cover performance testing at all phases of development, production, and field analysis of electrical terminals, connectors, and components that constitute the electrical connection systems in low voltage (0 - 20 VDC) road vehicle applications. These procedures are only applicable to terminals used for In-Line, Header, and Device Connector systems with and without Shorting Bars. They are not applicable to Edge Board connector systems, > 20 VAC or DC, or to eyelet type terminals.