SAE J2714_201502

1. SCOPE
2. REFERENCES
3. BASIC DEFINITIONS
4. STANDARD TEST CONDITIONS AND PARAMETER
    FLUCTUATION LIMITS
5. TEST EQUIPMENT
6. PUMP FUNCTIONAL TESTING
7. DURABILITY TESTING
8. PUMP INTEGRITY TESTING
9. DATA ANALYSIS AND PRESENTATION
10. NOTES
APPENDIX A - BLOCK DIAGRAM
APPENDIX B - EXTERNAL LEAKAGE DATA SHEET
APPENDIX C - INTERNAL LEAKAGE DATA SHEET
APPENDIX D - BASIC PERFORMANCE DATA SHEET
APPENDIX E - ADDITIONAL CHARACTERIZATION DATA SHEET
APPENDIX F - NOISE MEASUREMENTS DATA SHEET
APPENDIX G - DURABILITY MEASUREMENTS DATA SHEET
APPENDIX H - EXTERNAL CORROSION DATA SHEET
APPENDIX I - ENVIRONMENTAL TESTS DATA SHEET

Describes the minimum design verification testing that is recommended to verify the suitability of Gasoline Direct Injection (GDI) High Pressure fuel pumps used for pumping gasoline or gasoline blend fuels.

The scope of this Recommended Practice is limited to gasoline fuel pumps used in automotive direct fuel injection systems. It is primarily restricted to bench tests.This SAE Recommended Practice also defines the minimum design verification testing that is recommended to verify the suitability of Gasoline Direct Injection (GDI) High Pressure fuel pumps used for pumping gasoline or gasoline blend fuels. Additional tests not specified in SAE J2714 will be required for non-automotive pump applications or pumps, such as those intended for use on aircraft, motorcycles, or marine equipment.Except where stated, test results are recorded for individual parts under recommended test conditions. Where population characteristics are reported, the sample size, selection method, and statistical analysis technique must be explicitly stated.