SAE USCAR17
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PERFORMANCE SPECIFICATION FOR AUTOMOTIVE RF CONNECTOR SYTEMS
Hardcopy , PDF
26-03-2022
English
22-02-2002
Important note : Users cannot be edited or removed once added to your Multi user PDF.
1.0 SCOPE
2.0 REFERENCES
3.0 GENERAL REQUIREMENTS
4.0 TEST AND ACCEPTANCE REQUIREMENTS
5.0 TEST SEQUENCE
APPENDIX A - DEFINITIONS
APPENDIX B - WEDGE FOR MATING UNDER SIDE LOAD TEST
APPENDIX C - REVISIONS
Includes procedures for testing performance of SMB-style electrical terminals, connectors and components for coaxial cable connection systems intended for road vehicle applications.
| DevelopmentNote |
All previous revisions are still active. (12/2011)
|
| DocumentType |
Standard
|
| Pages |
10
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
Procedures included within this specification are intended to cover performance testing at all phases of development, production, and field analysis of electrical terminals, connectors and components for coaxial cable connection systems (hereafter referred to as RF connectors) in road vehicle applications. The intent of this specification is to qualify RF connectors that operate at frequencies greater than 200 MHz. This specification does not apply to single conductor wire or twisted pair connection systems. The RF connection system will be qualified for specific coaxial cable; the qualified coaxial cable and frequency range of interest must be listed on the connector drawing. Changing coaxial cable necessitates re-qualification.This specification is a supplement to the SAE/USCAR-2 Performance Standard for Automotive Electrical Connector Systems and all requirements herein must be met in addition to all requirements of SAE/USCAR-2, unless otherwise specified. Only RF connector related additions and/or subtractions to the SAE/USCAR-2 specification are contained in this document.
| BS ISO 22902-7:2006 | Road vehicles. Automotive multimedia interface Physical specification |
| SAE USCAR29 | Automotive Grade Coaxial Cable Performance Specification |
| ISO 22902-7:2006 | Road vehicles Automotive multimedia interface Part 7: Physical specification |
| SAE USCAR19 | COAXIAL CABLE CONNECTOR INTERFACE – SQUARE OUTER CONDUCTOR |
| SAE USCAR18 | FAKRA SMB RF CONNECTOR SUPPLEMENT |
| SAE USCAR2-6 | Performance Specification for Automotive Electrical Connector Systems |
| IEC 62153-4-7:2015 | Metallic communication cable test methods - Part 4-7: Electromagnetic compatibility (EMC) - Test method for measuring of transfer impedance Z<sub>T</sub> and screening attenuation a<sub>S</sub> or coupling attenuation a<sub>C</sub> of connectors and assemblies up to and above 3 GHz - Triaxial tube in tube method |
| SAE USCAR18 | FAKRA SMB RF CONNECTOR SUPPLEMENT |
| SAE USCAR25-1 | ELECTRICAL CONNECTOR ASSEMBLY ERGONOMIC DESIGN CRITERIA |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.