SAEITC TS110-2

1 Introduction and Scope
2 Limitations
3 Tube materials
4 Tools and equipment
5 Preparation of tube ends and fittings
6 Swaging procedure - general requirements
7 Visual inspection
8 Proof pressure testing
9 Reswaging of pipe assemblies
10 Quality Control tests
Appendix A - Swaging Machine Type 2000 - Swaging
             procedure
Appendix B - Swaging Machine Type 1000 - Swaging
             procedure
Appendix C - Maintenance and inspection requirements
             for swaging machine Types 1000 and 2000
Appendix D - Requirements for tube materials
Figure 1 - Minimum length of straight tube required
           prior to swaging
Figure 2 - Illustrations of swaged joints
Figure 3 - Illustration of pressure test specimen
Figures 4 and 5 - Illustrations applicable to
                  measurement of tube wall thickness
                  and groove penetration
Figures 6 to 9 - Illustrations applicable to Types
                 1000 and 2000 swaging machines
Table 1 - Type CM tube expander references and
          expansion ranges
Table 2 - Sizing and swaging data for use with Types
          1000 and 2000 swaging machines

Defines a procedure, using an approved jointing compound (see clause 1.5), for swaging tubes into AS 43022 and AS 43160 (Nipples) and AS 43024 and AS 43161 (Unions) swaged end fittings used in the manufacture of pipe assemblies for aircraft fluid systems, as qualified by clauses 1.2 and 1.3, in order to achieve the standard necessary to comply with the requirements of TS 100.