SN EN 12452 : 2012

Foreword
1 Scope
2 Normative references
3 Definitions
4 Designations
      4.1 Material
      4.2 Material condition
      4.3 Product
5 Ordering information
6 Requirements
      6.1 Composition
      6.2 Mechanical properties
      6.3 Dimensions and tolerances
      6.4 Tolerances of form
      6.5 Surface quality
      6.6 Technological requirements
7 Sampling
      7.1 General
      7.2 Analysis
      7.3 Mechanical tests
8 Test methods
      8.1 Analysis
      8.2 Tensile test
      8.3 Hardness test
      8.4 Technological tests
      8.5 Freedom from defects tests
      8.6 Retests
      8.7 Rounding of results
9 Declaration of conformity and inspection documentation
      9.1 Declaration of conformity
      9.2 Inspection documentation
10 Marking, packaging, labelling
Table 1 - Composition of copper and copper alloys
Table 2 - Mechanical properties of copper and copper alloy
          tubes before finning
Table 3 - Tolerances on outside diameter
Table 4 - Tolerances on length
Table 5 - Tolerances on fin pitch
Table 6 - Sampling rate
Annex A (informative) Bibliography
Annex B (normative) Freedom from defects tests
Annex ZA (informative) Clauses of this European Standard
                       addressing essential requirements or
                       other provisions of EU Directives

Defines the composition, tolerances and property requirements on dimensions and form for finned, rolled, seamless copper and copper alloy tubes for heat exchangers supplied in the size range from 6 mm up to and including 35 mm outside diameter and from 1 mm up to and including 3 mm wall thickness of the unfinned section and fin height up to and including 1,5 mm.