SN EN 1337-6 : 2004

Foreword
1 Scope
2 Normative references
3 Terms, definitions and symbols
   3.1 Terms and definitions
   3.2 Symbols
4 Functional requirements
   4.1 General
   4.2 Load bearing capacity
   4.3 Rotation capability
5 Materials
   5.1 General
   5.2 Carbon steel
   5.3 Stainless steel
   5.4 Cast steel
   5.5 Cast iron
6 Design
   6.1 General
   6.2 Curved surfaces
   6.3 Surfaces in contact
   6.4 Preventing of sliding
   6.5 Dimensioning of components
        6.5.1 Dimensions of line rocker
        6.5.2 Point rocker in spherical seating
        6.5.3 Point rocker on a flat surface
        6.5.4 Load distribution to other components
   6.6 Particular requirements
        6.6.1 Corrosion in the contact line or point
        6.6.2 Alignment
        6.6.3 Line rocker rotational eccentricity
        6.6.4 Point rocker rotational eccentricity
        6.6.5 Eccentricity due to horizontal load
        6.6.6 Total eccentricity
        6.6.7 Limiting rotation condition
   6.7 Combination with other elements
7 Tolerances
   7.1 Flatness
   7.2 Surface profile
   7.3 Surface roughness
   7.4 Parallelism of contact surfaces
8 Conformity evaluation
   8.1 General
   8.2 Control of the construction product and its
        manufacture
        8.2.1 Factory production control (FPC)
        8.2.2 Initial type testing
        8.2.3 Routine testing
   8.3 Raw materials and constituents
9 Installation
10 In-service inspection
Annex A (normative) Ferrous materials
Annex B (informative) Factory Production Control (FPC)
        B.1 General
             B.1.1 Objectives
             B.1.2 Documentation
             B.1.3 Operations
        B.2 Verifications and tests
             B.2.1 General comments
             B.2.2 Monitoring of conformity
             B.2.3 Tests
             B.2.4 Treatment of construction products which
                   do not conform
             B.2.5 Recording of verifications and tests
                   (manufacturer's register)
        B.3 Traceability
Annex ZA (informative) Clauses of this European Standard
         addressing the provisions of the EU Construction
         Products Directive
         ZA.1 Scope and relevant characteristics
         ZA.2 Procedure(s) for attestation of conformity of
              rocker bearings
         ZA.3 CE marking and labelling
Bibliography

Covers the requirements for the design and manufacture of rocker bearings.