SN EN 14876 : 2007

Foreword
Introduction
1 Scope
2 Normative references
3 Intervals between periodic inspection and test
4 List of procedures for periodic inspection and test
5 Identification of pressure drum and preparation for
   inspection and test
6 Depressurization and de-valving procedures
7 External visual inspection
8 Internal visual inspection
9 Supplementary tests
10 Inspection of openings
11 Pressure test
12 Pressure drum repair
13 Inspection of valves
14 Final operations
15 Rejection and rendering pressure drum unserviceable
Annex A (informative) - Pressure drums manufactured
        according to National Regulations
Annex B (normative) - Inspection periods
Annex C (normative) - Description, evaluation of defects
        and conditions for rejection of welded steel
        pressure drums at the time of visual inspection
Annex D (normative) Procedure to be adopted when de-valving
        and when a valve is suspected to be obstructed
Bibliography

Applies to welded steel transportable pressure drums intended for compressed and liquefied gases under pressure of water capacity from 150 litres up to 1000 litres. Describes the requirements for periodic inspection and testing to verify the integrity of such pressure drums to be re-introduced into service for a further period of time.