SN EN 1652 : 1998 CORR 2004

Foreword
1 Scope
2 Normative references
3 Definitions
    3.1 Plate
    3.2 Sheet
    3.3 Strip
    3.4 Circle
4 Designations
    4.1 Material
    4.2 Material condition
    4.3 Product
5 Ordering information
6 Requirements
    6.1 Composition
    6.2 Mechanical properties
    6.3 Grain size
    6.4 Dimensions and tolerances
    6.5 Edgewise curvature c
    6.6 Surface condition
7 Sampling
    7.1 General
    7.2 Analysis
    7.3 Tensile, hardness, grain size and technological
          tests
8 Test methods
    8.1 Analysis
    8.2 Tensile test
    8.3 Hardness test
    8.4 Estimation of average grain size
    8.5 Technological tests
    8.6 Retests
    8.7 Rounding of results
9 Declaration of conformity and inspection of documentation
    9.1 Declaration of conformity
    9.2 Inspection of documentation
10 Marking, packaging, labelling
Annex A (informative) Bibliography
Figure 1 Edgewise curvature c
Table 1 Composition of copper
Table 2 Composition of copper alloys
Table 3 Mechanical properties
Table 4 Tolerances on thickness of hot rolled products
          (plate, sheet, strip and circles)
Table 5 Tolerances on thickness of cold rolled products
          (sheet, strip and circles)
Table 6 Tolerances on width of cold rolled strip
Table 7 Tolerances on width of plate and sheet
Table 8 Tolerances on length of plate, sheet and strip
          cut to length for lengths up to 5000 mm
Table 9 Squareness of cut plate and sheet
Table 10 Tolerances on diameter for circles
Table 11 Edgewise curvature

Defines the composition, property requirements and tolerances on dimensions and form for copper and copper alloy plate, sheet, strip and circles for general use.