SN EN 1870-14 : 2008 + A2 2012

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or measures
  5.1 General
  5.2 Controls
      5.2.1 Safety and reliability of control systems
      5.2.2 Position of controls
      5.2.3 Starting
      5.2.4 Normal stopping
      5.2.5 Emergency stop
      5.2.6 Cutting cycle on vertical panel sawing
            machines with integrated feed
      5.2.7 Speed changing
      5.2.8 Failure of the power supply
      5.2.9 Failure of the control circuits
  5.3 Protection against mechanical hazards
      5.3.1 Stability
      5.3.2 Hazard resulting from break-up during
            operation
      5.3.3 Tool holder and tool design
      5.3.4 Braking
      5.3.5 Devices to minimise the possibility or
            the effect of ejection
      5.3.6 Work piece supports and guides
      5.3.7 Prevention of access to moving parts
      5.3.8 Guarding of drives
  5.4 Protection against non-mechanical hazards
     5.4.1 Fire
     5.4.2 Noise
     5.4.3 Emission of chips and dust
     5.4.4 Electricity
     5.4.5 Ergonomics and handling
     5.4.6 Pneumatics
     5.4.7 Electromagnetic compatibility
     5.4.8 Static electricity
     5.4.9 Errors of fitting
     5.4.10 Supply disconnection (isolation)
     5.4.11 Maintenance
6 Information for use
  6.1 Warning devices
  6.2 Marking
      6.2.1 Marking of the machine
      6.2.2 Marking of riving knives and pressure shoes
  6.3 Instruction handbook
Annex A (informative) Use of well tried components
Annex B (normative) Impact test method for guards
      B.1 General
      B.2 Test method
          B.2.1 Preliminary remarks
          B.2.2 Testing equipment
          B.2.3 Projectile for guards
          B.2.4 Sampling
          B.2.5 Test procedure
      B.3 Results
      B.4 Assessment
      B.5 Test report
      B.6 Test equipment for impact test
Annex C (normative) Saw spindle dimensional
                    tolerances
Annex D (normative) Riving knife mounting
                    strength test
Annex E (normative) Riving knife testing - Lateral
                    stability
Annex F (normative) Braking tests
      F.1 Conditions for all tests
      F.2 Tests
          F.2.1 Un-braked run-down time
          F.2.2 Braked run-down time
Annex G (normative) Use of electronic components
      G.1 General
      G.2 SRECS design
          G.2.1 Components, hardware
          G.2.2 Safety related software
Annex ZA (informative) Relationship between this
                       European Standard and the
                       Essential Requirements of
                       EU Directive 98/37/EC
Bibliography

It deals with the significant hazards, hazardous situations and events as listed in Clause 4 which are relevant to manually loaded and unloaded vertical panel sawing (with or without integrated feed) machines fitted with: - the facility for scoring; - an angle cutting device; - a middle support device; - a programmable stop for parallel vertical cuts; - the facility for grooving with a width of at most 20 mm in one pass by using a milling tools.